zoom_in
PMI Quick Rip fast-tear screen printing tape
- Reference: PMI-Quick-Rip-Tape
€7.90 Tax excluded
Description
PMI Quick Rip #260 is a transparent screen printing tape in 5.08 cm. It is built for fast application on the press side. PMI Tape makes tapes shaped for the pace of busy shops.
Its backing tears clean by hand, in a single snap. No scissors or blade are needed. The cut stays straight and clean, strip after strip. This fast-tear screen printing tape is the quickest to apply in the PMI range.
In a busy shop, taping happens on every screen. Seconds saved per strip add up across high volumes. This speed keeps setup close to production pace. It suits manual and automatic work alike.
The adhesive covers the full surface and holds firm. It stays put through vibration and squeegee pressure. This masking tape blocks pinholes and open mesh. It also seals the frame edges against ink bleed.
The transparent film shows the area under the tape. Masking stays precise, even over a small defect. The tape works with plastisol, water-based and discharge inks. No special prep is needed before printing.
Removal is clean, with no residue and no solvent. The adhesive lifts off the mesh in one pull. The stencil stays intact for reuse. The screen moves fast to the next job.
Quick Rip is the fast-tear tape of the PMI range. To protect the inner frame edges, the screen frame protection tape works well. To mask wide full areas, the screen masking tape is a better fit. The Quick Rip completes the PMI screen printing supplies range.
Features of the PMI Quick Rip fast-tear screen printing tape
- Transparent tape, 5.08 cm wide;
- Quick snap-tear by hand, no scissors or dispenser;
- Full-surface adhesive, direct hold on the mesh;
- Holds through automatic press runs;
- Blocks pinholes, open mesh and frame edges;
- Residue-free removal, no solvent needed.
PMI Quick Rip #260 FAQ
What makes Quick Rip different? Its backing tears fast and clean by hand. It is the quickest PMI tape to apply.
Does it hold on automatic presses? Yes. It resists vibration and squeegee pressure through full runs.
Which inks does it suit? It works with plastisol, water-based and discharge inks.
Does it leave residue? No. It peels off clean, with no solvent and no damage to the stencil.
