Hot Peel DTF Film Roll | DTF Transfer Roll 60 cm x 100 m for DTF Printer
- Reference: RLDTF60X100HP
€140.00 Tax excluded
Description
Hot Peel DTF transfer film optimises the quality of your print and typically reduces the cost of production. This 60 cm x 100 m hot peel DTF film roll retains a maximum of ink, which the DTF printer deposits, with a really high ink rate.
Used with our inks, the DTF transfer remains identical to the original file, with vibrant colours.
The matte coating on the non-printable side allows the DTF hot peel transfer film to pass through the printing system with low friction. This prevents it from charging with static electricity.
This film for DTF peels off immediately after using the Sefa heat press for best results. No need to press twice or wait for it to cool down.
The best value hot peel DTF transfer film that increases productivity without sacrificing quality.
Principal advantages of DTF Heat Peel Transfer Film.
- PET film offering a high ink rate;
- Good colour reproduction;
- The hot melt powder only adheres to the DTF ink, not to the film;
- The film for DTF Hot Peel renders a nice scale opacity;
- Saves peel time compared to DTF Cold Peel film;
- Facilitate the application of transfer on t-shirt;
- No banding effect from the DTF printer.
DTF printer setting and powder machine with DTF Hot Peel film.
The hot peel DTF transfer film doesn't demand any specific settings for printing or drying the DTF powder. Start testing with the usual settings. Adjust if necessary to correspond to your textile printing equipment.
How to apply the DTF hot peel transfer.
DTF or Direct-To-Film printing makes it possible to mark a large majority of textiles, in cotton, lycra, polyester. Below are installation tips for a DTF transfer depending on the garment:
- Cotton: Set heat press to 150°C and press for 12 seconds;
- Cotton/polyester mix: 135°c and press for 10s;
- Sensible fabric: 125°c and heat presses for 8s.
Warning, results not guaranteed, always carry out tests before putting into production.
How to remove a DTF transfer and save your t-shirt.
Sometimes the DTF transfer is unapplied correctly or placed in the wrong place. Nothing problematic, if you still have a piece of clothing in advance. To save your textile you can use a DTF transfer solvent.
Apply a few drops of Flex Remover (DTF Remover). Wait a few seconds for the solvent for DTF to dissolve the transfer. Remove it using a pair of weeding pliers. You have just easily corrected a printing defect on a textile.
A roll film for DTF transfer compatible with the majority of DTF printers and DTF inks.
Hot peel DTF Transfer film is suitable for major DTF printer manufacturers such as:
- Oric DTF printing line;
- Haiya textile printer;
- Audley DTF printer;
- Mycolor;
Also principal manufacturers like DTF Pro, DTF Superstore, Mongoose, Binterjet or Kingjet.
RIP software for DTF printing.
DTF printers all work with RIP software. The RIP (Raster Image Processor) transmits information like the amount of DTF ink of each colour needed for printing. It allows you to print a visual in colour with white ink on the surface.
The hot peel DTF transfer film is suitable for RIPs like CaDlink, Acrorip, Ekprint, Devstudio, Flexi Sai, Flexi print, Wasatch SoftRIP, White RIP, Maintop…
How to prepare a DTF print file.
The basis of a good textile print is a file of excellent quality. Start by saving your visual with a transparent background. We recommend .ps, .ai, and high resolution .png or jpeg formats. Set the resolution to 300 dpi and the colorimetric mode to CMYK, remember to leave a margin of 0.5 to 1 cm to facilitate the cutting of the DTF transfer.
Avoid using a gradient to transparency.