SCHULZE Combo 4050 | Powder Shaker and Dryer for DTF Sheets

Description

When you print on DTF sheets, the powdering is most often done by hand. The powder is poured into a plastic tray, each sheet is shaken to remove the excess, then the surplus scattered around is collected. Results vary from one sheet to the next and the powder ends up spreading across the workshop. Drying then relies on the heat press, or at best on a separate DTF oven: two machines, two handling steps.

The SCHULZE DTF Combo 4050 brings these two steps together and automates them. Powdering becomes consistent, the surplus is recovered automatically and drying follows straight after, all in a closed system. You prepare your transfers more cleanly, with fewer steps and a consistent result on every run.

The SCHULZE DTF Combo 4050 is a powder shaker and dryer for DTF sheets up to 40 × 50 cm. The machine removes manual powdering and reduces handling between each step.

You save time, keep a cleaner workstation and prepare transfers more easily.

After printing, the Combo 4050 applies powder to the DTF film. It removes the excess, recovers the surplus and prepares the transfer before heat pressing.

Automatic DTF powdering and integrated drying with DTF oven

The SCHULZE DTF Combo 4050 brings two production steps together in one machine. You work with a DTF powder shaker for sheets and an integrated DTF oven, without installing two separate units.

The transfers move from powdering to drying on the same workstation. You handle the films less and keep a clearer working area.

The integrated DTF oven makes inserting and removing the sheets easier. You adjust the time and temperature according to your powder, DTF films and production pace.

Apply DTF powder to your sheets with greater consistency

The powdering system automatically applies DTF powder to the printed sheets. The tapping system then removes the surplus after application.

The DTF powder stays on the printed areas. The excess is removed without manual recovery after each sheet.

You reduce repetitive handling during powdering. The finish stays more consistent across small runs and repeated production.

Automatic recovery system for surplus DTF powder

The SCHULZE DTF Combo 4050 automatically recovers surplus powder after powdering. A paddle conveyor brings the excess back to the reservoir.

You no longer recover the powder by hand and the system does not need refilling after each sheet.

This process limits consumable losses and reduces powder waste during production runs.

Compact DTF powder shaker and dryer for small spaces

The Schulze powder shaker and dryer brings powdering and drying together on one workstation. Its compact format makes it easier to install in workshops with limited space.

It works as a closed system. The doors limit powder release during production. Less DTF powder spreads around the machine, so the workshop stays cleaner, especially during longer runs.

The antistatic strips reduce the effects of static electricity on the films and powder. The sheets move more smoothly during powdering.

Precise drying and powdering settings for DTF films

The SCHULZE DTF Combo 4050 is easy to set up. You set the temperature, drying time and tapping duration.

The temperature reaches up to 150 °C. The drying time can be set up to 5 minutes. The tapping system can be set up to 99 seconds.

These settings help you work with different DTF films and powders. You keep production consistent without changing your usual workshop process.

With automatic powdering, an integrated DTF oven and powder recovery, the SCHULZE DTF Combo 4050 simplifies transfer preparation. It helps DTF workshops produce more cleanly, with less handling and better control over each run.